25
Installing Acunetix WVS
Installing Acunetix WVS
25
2.4
Configuring a Proxy Server
Screenshot 17 - LAN HTTP Proxy Settings
If your machine is sitting behind a proxy server and you need Acunetix WVS
to use this proxy, then you need to configure the proxy server settings.
From the Tools Explorer Panel on the far left-hand side of the user interface,
select Configuration > Settings. Then select Application Settings > LAN
Settings to access the configuration panel as shown above..
Acunetix WVS supports both HTTP
and SOCKS proxy settings. You can
setup the Acunetix Web Vulnerability
Scanner
to use both technologies
concurrently.
HTTP Proxy Settings
Use an HTTP proxy server – Tick the check box to make Acunetix WVS use
an HTTP proxy server.
Hostname and Port
–
Hostname (or IP address) and port number of the
HTTP proxy server.
Username and Password
–
Credentials used to access the
proxy. If no
authentication is required, leave these options empty.
SOCKS Proxy Settings
Use a SOCKS proxy server –
Tick the check box to make Acunetix WVS
use a SOCKS proxy server.
Hostname and Port
–
Hostname (or IP
address) and port number for the
SOCKS proxy server.
Protocol
–
Select which SOCKS protocol to use. Both Socks v4 or v5
protocols are supported by Acunetix WVS.
Username and Password – The credentials used to access this proxy. If no
authentication is required, leave these options empty.
 |
 |
 |